Your Guide To Accessing Netgear Router Set Up

Setting up a wireless router is easy. Essentially, you disable your cable modem or DSL and your wireless router. Next, you connect the router to the modem with a cable and turn the modem back on. You are more or less done. The wireless network assistant on your computer will take the router and, if your ISP does not have any special needs, far-you-go, you are on the Internet.

On your main PC (the server), open Control Panel -> double-click Network Connections -> right-click your network connection (the one that connects the two computers) and select Properties -> select TCP / IP and click Properties “button Click Use the following IP address and enter the IP address: 192.168.1.1 Subnet mask: 255.255.255.0, leave the default checkbox blank Select Use The following DNS server addresses, but leave them blank.

Now, you will be asked to enter a username and password for the router. This would initially be given by your Internet service provider (ISP) which can be changed later. Once connected, you will usually find a tab that reads the wireless network settings. You will need to activate the network using button provide for the same. Once completed, you can remove your Ethernet cable and try to connect to the wireless network.

So how do you know the MAC address of the wireless card of the computer you are using? It is very simple! Open a command editor by typing the cmd command in the Start -> Run window. Then, type ipconfig / all. From the output, find your wireless card name and you will see the MAC address after a few lines.

Make sure the modem and router are plugged into the electrical outlet. See if the lights light up on the front of them. If the modem and router have lights on the front, follow the instructions below. Otherwise, you know which one is not working.

The request for comments or also called RFC defines 192.168.1.1. As one of the addresses that people can use for private use or access to the Internet. With this Internet Protocol address are other addresses in the range of 10.0.0.0 to 10.255.255.255 and 172.16.0.0 to 172.31.255.255. To identify the address set, RFC points to 10.0.0.0 to 10.255.255.255 as a 24-bit block, 172.16.0.0 to 172.31.255.255 as a 20-bit block, and 192.168.0.0 to 192.168.255.255 as a 16-bit block.

But, being convenience can have its disadvantages too. In fact quite dangerous. Imagine, a stranger who is near you, has detected your home wireless network and connects you to your home wireless network. Now, abroad can use free Internet access, or maybe free information from your computer. The foreigner with sufficient knowledge and tools can actually access any computer that connects to the network. It can even block your computer from the network! Now it’s bad. You can not use your own wireless network !! ??

In order to understand the concept of their operation, they can be compared to something more familiar like phone numbers. Any phone number you call has a specific dedicated phone. So if you want to call your mother, you have to dial her number and know she would be the person to answer.

Connect to your router (in the same way above) and navigate to the Configuration page. Highlight the Applications and Games tab. Click the Port Range Forward option. Enter all the information in the appropriate fields, select TCP or UDP on the Protocol tab. When you are finished, review the information and click the Save Settings button. Exit the router interface and enjoy access to applications that were blocked by your firewall.